Projects / Ideas / Solder flux wetting test

Solder flux wetting test

BeginnerHome LabIdeaReviewed
In short

How do you build a solder flux wetting test?

Solder identical dabs on clean copper with and without flux, and on a dull and a polished piece, then look at each under a USB microscope. You see how flux helps solder spread and why a clean surface matters. Work in the open air with fume extraction, and wash your hands afterwards. You need Copper clad board (single side) 10 × 15 cm, Soldering flux paste, Solder wire 60/40 (0.8 mm, 50 g), Soldering iron 60 W (adjustable temperature), Isopropyl alcohol 99 % (flux cleaner) and USB microscope.

Level
Beginner
Time
About 60 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See what flux does to a solder joint.

How to build it

  1. Cut four copper squares
  2. Clean two and sand two
  3. Solder with and without flux
  4. Clean off the flux
  5. Photograph each under the microscope and compare

Related projects

Common questions

What parts do I need for the solder flux wetting test?

Copper clad board (single side) 10 × 15 cm, Soldering flux paste, Solder wire 60/40 (0.8 mm, 50 g), Soldering iron 60 W (adjustable temperature), Isopropyl alcohol 99 % (flux cleaner) and USB microscope.

How long does the solder flux wetting test take to build?

About 60 minutes for a beginner maker.