Projects / Ideas / SPI flash chip ID reader

SPI flash chip ID reader

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build an SPI flash chip ID reader?

Read the manufacturer and device ID of a W25Q flash chip with a CH341A programmer, after checking with a meter that the programmer outputs 3.3 V on its data lines. You need CH341A programmer, W25Q128 SPI flash 16 MB, Jumper wires male to male (40 pcs, 20 cm) and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 120 min
Parts
4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Identify a flash chip safely.

How to build it

  1. Measure the programmer data-line voltage first
  2. Identify pin 1 on the chip
  3. Wire the chip to the 3.3 V socket
  4. Read the chip ID only
  5. Compare it with the datasheet

Related projects

Common questions

What parts do I need for the SPI flash chip ID reader?

CH341A programmer, W25Q128 SPI flash 16 MB, Jumper wires male to male (40 pcs, 20 cm) and Breadboard 830 Tie Points.

How long does the SPI flash chip ID reader take to build?

About 120 minutes for a intermediate maker.