Projects / Ideas / Formaldehyde check for new furniture

Formaldehyde check for new furniture

IntermediateEnvironmentIdeaReviewed
In short

How do you build a formaldehyde check for new furniture?

A ZE08-CH2O sensor reports formaldehyde in ppm from new plywood furniture, so you know when a room is safe to use. You need Arduino Nano, ZE08-CH2O formaldehyde sensor, SSD1306 OLED Display, LED 5 mm green, LED 5 mm red and Resistor 220 Ω × 2.

Level
Intermediate
Time
About 75 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Read a factory-calibrated electrochemical sensor over UART and display ppm against guideline limits.

Parts list

How to build it

  1. Wire the ZE08 TX to a SoftwareSerial pin at 9600 baud
  2. Parse its 9-byte active-upload frame and check the checksum
  3. Convert to ppm and mg/m³
  4. Show green below 0.08 ppm and red above
  5. Log readings in a new-furniture room for a week with windows shut overnight

Related projects

Common questions

What parts do I need for the formaldehyde check for new furniture?

Arduino Nano, ZE08-CH2O formaldehyde sensor, SSD1306 OLED Display, LED 5 mm green, LED 5 mm red and Resistor 220 Ω × 2.

How long does the formaldehyde check for new furniture take to build?

About 75 minutes for a intermediate maker.