Idea
In short
How do you build a push-pull speaker driver?
An NPN and a PNP transistor take turns to drive a small speaker from a phone or tone source. You need BC548 NPN transistor, BC557 PNP transistor, Resistor 1 kΩ × 2, Resistor 10 kΩ, Potentiometer 10 kΩ, Speaker 8 Ω 0.5 W, Electrolytic Capacitor 100 µF, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a complementary driver.
Parts list
- Semiconductors
- Semiconductors
- PassivesResistor 1 kΩ × 2
- Passives
- Passives
- Motors & Actuators
- Passives
- Batteries
- Power
- Prototyping
How to build it
- Draw the stage
- Bias with the resistors
- Feed a tone
- Listen to the crossover noise
- Add a small bias fix
Common questions
What parts do I need for the push-pull speaker driver?
BC548 NPN transistor, BC557 PNP transistor, Resistor 1 kΩ × 2, Resistor 10 kΩ, Potentiometer 10 kΩ, Speaker 8 Ω 0.5 W, Electrolytic Capacitor 100 µF, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the push-pull speaker driver take to build?
About 240 minutes for a intermediate maker.
