Idea
In short
How do you build a one-transistor amplifier bias lab?
Build a common-emitter stage with a low-noise transistor, set the bias, and see the gain and clipping on a scope or meter. You need BC549 low-noise NPN, Resistor 33 kΩ, Resistor 5.6 kΩ, Resistor 6.8 kΩ, Electrolytic capacitor 47 µF, Ceramic capacitor 100 pF, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 150 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Bias a transistor amplifier.
Parts list
- Semiconductors
- Passives
- Passives
- Passives
- Passives
- Passives
- Batteries
- Power
- Prototyping
How to build it
- Calculate the divider bias
- Check the collector voltage
- Add a small signal
- Measure the gain
- Raise the signal until it clips
Common questions
What parts do I need for the one-transistor amplifier bias lab?
BC549 low-noise NPN, Resistor 33 kΩ, Resistor 5.6 kΩ, Resistor 6.8 kΩ, Electrolytic capacitor 47 µF, Ceramic capacitor 100 pF, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the one-transistor amplifier bias lab take to build?
About 150 minutes for a beginner maker.
