How do you build an audio signal tracer probe?
A probe with a capacitor in series feeds a small amplifier and speaker, so you can follow an audio signal through a circuit and hear where it stops. A classic repair tool for radios and amplifiers. Keep the volume low and never probe mains circuits. You need LM386 amplifier module, Speaker 8 Ω 0.5 W, Ceramic Capacitor 100 nF, Resistor 10 kΩ, Potentiometer 10 kΩ, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 80 min
- Parts
- 9
Hear a signal along an audio circuit.
Parts list
- Audio
- Motors & Actuators
- Passives
- Passives
- Passives
- Batteries
- Power
- Prototyping
- Prototyping
How to build it
- Build the probe lead with a series capacitor
- Feed the amplifier input
- Set the volume with the pot
- Trace a tone from a phone
- Find a deliberately broken stage
Common questions
What parts do I need for the audio signal tracer probe?
LM386 amplifier module, Speaker 8 Ω 0.5 W, Ceramic Capacitor 100 nF, Resistor 10 kΩ, Potentiometer 10 kΩ, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the audio signal tracer probe take to build?
About 80 minutes for a intermediate maker.
