Idea
In short
How do you build a regulator dropout tester?
Drain a battery slowly through a 5 V regulator and find the input voltage where the output starts to sag. You need AMS1117 5 V regulator, Electrolytic capacitor 10 µF, Electrolytic Capacitor 100 µF, Resistor 1 kΩ, Potentiometer 10 kΩ, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Find the dropout point.
Parts list
- Power
- Passives
- Passives
- Passives
- Passives
- Batteries
- Power
- Prototyping
How to build it
- Wire the regulator with caps
- Add a light load
- Lower the input in steps
- Record the output
- Note the dropout
Common questions
What parts do I need for the regulator dropout tester?
AMS1117 5 V regulator, Electrolytic capacitor 10 µF, Electrolytic Capacitor 100 µF, Resistor 1 kΩ, Potentiometer 10 kΩ, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the regulator dropout tester take to build?
About 180 minutes for a intermediate maker.
