Learn / Sensors and actuators / Motors and drivers

Actuators, Motor Drivers & Protection

ReviewedIntermediate MakerAbout 5 min
BME280
In short

Actuators, Motor Drivers & Protection: the short answer

An actuator turns electricity into movement, light, heat or sound: motors, servos, steppers, relays, solenoids, buzzers. Each needs more current than a pin can give, so a driver sits between them.

Level
Intermediate
Time
About 5 min
Topic
Sensors and actuators
You will learn to

Pick the right driver for motors, servos, steppers and relays, and size the supply.

Before this: Transistors & MOSFET Switching, Motor Power and Drivers

An actuator turns electricity into movement, light, heat or sound: motors, servos, steppers, relays, solenoids, buzzers. Each needs more current than a pin can give, so a driver sits between them.

Match the driver to the actuator. A transistor or MOSFET switches a load on and off. An H-bridge (TB6612FNG, L298N) runs a DC motor both ways. A stepper driver or ULN2003 board sequences a stepper's coils. A relay module switches a separate circuit, even mains, through an isolated contact. Servos have a driver built in and only need a signal pin plus a supply that can deliver their peak current.

Size the supply from the worst case: start-up and stall current, all actuators at once. Add a flyback diode for any coil you switch yourself (relay modules usually include one). Keep the motor supply separate from the logic supply and join the grounds.

Match the interface to the load

A microcontroller pin supplies a few milliamps, so anything bigger needs a switch between them. A transistor or MOSFET drives a small motor, a buzzer or a solenoid. A relay switches a bigger or higher-voltage load and keeps it electrically apart from the controller. A motor driver chip handles direction and speed. A servo has its own driver inside and needs only a control pulse and a good power supply.

Work out the load's running current and its start-up current before you choose. A solenoid or motor can draw several times its running current when it starts.

Protection for the controller

Coils store energy and, when switched off, push a voltage spike back into the circuit. A flyback diode across the coil gives that energy a path. Keep the load's power wiring and ground separate from the controller's sensitive signals and join them at one point, so that load current does not shift the reference your ADC reads.

Add a fuse or a current limit, and decide the safe state if the controller crashes: a relay that stays on can be dangerous, so choose normally-open or add a hardware limit where it matters.

Test with the load attached

Test at the real supply voltage with the real load, and check the temperature of the driver after a few minutes. A circuit that works on the bench with the load disconnected can reset the controller when the load starts.

Common mistakes
  • Driving a coil or motor straight from a microcontroller pin.
  • Leaving out the flyback diode.
  • Not deciding what the actuator does when the controller crashes.
Intermediate lesson · Maker plan

Practise this lesson with Maker

The explanation above is free for everyone. The practice for Intermediate lessons in every domain are part of the Maker plan at ₹499 a month, and Pro includes them too.

With Maker you also get: a worked example, a hands-on task, a 3-question check.

Common questions

What will I learn in "Actuators, Motor Drivers & Protection"?

Pick the right driver for motors, servos, steppers and relays, and size the supply.