Learn / Basics / Series and parallel

Kirchhoff's Laws

ReviewedIntermediate MakerAbout 6 min
Vout = 2.5 V
In short

Kirchhoff's Laws: the short answer

Kirchhoff's current law (KCL) says that the current flowing into any junction equals the current flowing out. Charge does not pile up in a wire, so if 10 mA enters a node and one branch takes 4 mA, the other branches must take 6 mA between them.

Level
Intermediate
Time
About 6 min
Topic
Basics
You will learn to

Use Kirchhoff's current and voltage laws to solve circuits that are not simple series or parallel.

Before this: Resistor Networks & Loading

Kirchhoff's current law (KCL) says that the current flowing into any junction equals the current flowing out. Charge does not pile up in a wire, so if 10 mA enters a node and one branch takes 4 mA, the other branches must take 6 mA between them.

Kirchhoff's voltage law (KVL) says that around any closed loop, the voltage rises add up to the voltage drops. Walk around the loop: a battery raises the voltage, every resistor carrying current lowers it, and you end where you started. This is why the drops across resistors in series always add up to the supply.

To solve a circuit, label the unknown currents with arrows (any direction; a negative answer just means it flows the other way), write KCL at each junction and KVL around enough loops, and solve the equations. For many practical circuits it is quicker to combine resistors first, but KCL and KVL are what you fall back on when a circuit has two supplies, a bridge, or a sensor loading a divider. They are also the best way to check measurements: if the drops you measure do not add up to the supply, a reading or a connection is wrong.

Two laws, two conservation ideas

The current law says the currents flowing into a node add up to the currents flowing out, because charge does not pile up at a point. The voltage law says the voltage rises and drops around any closed loop add up to zero, because energy is conserved. Together they let you solve any circuit, however tangled.

A sign convention keeps the algebra honest. Pick a direction for each current, even if you guess wrong. If the answer comes out negative, the current simply flows the other way.

A routine that works every time

Label the nodes and the currents, choose a loop direction, write one equation per independent loop or node, then solve. A circuit with three unknown currents needs three independent equations. Check the result by confirming that the currents at every node balance and that the power supplied equals the power used by the parts.

Where it helps on a real bench

When a measured voltage does not match your calculation, walk the loop and add up the drops. The missing volts show you which part is not behaving, such as a connector with resistance or a battery that sags under load.

Common mistakes
  • Mixing up the sign of a drop when going against the current.
  • Writing more equations than unknowns using loops that are not independent.
  • Not checking the answer by confirming that power in equals power out.
Key formulas
ΣI in = ΣI out
KCL: currents into a node equal currents out
ΣV around a loop = 0
KVL: rises and drops round any closed loop cancel

Work it with your own numbers: Resistor networks · Loaded divider

Intermediate lesson · Maker plan

Practise this lesson with Maker

The explanation above is free for everyone. The practice for Intermediate lessons in every domain are part of the Maker plan at ₹499 a month, and Pro includes them too.

With Maker you also get: a worked example, a hands-on task, a 3-question check.

Common questions

What will I learn in "Kirchhoff's Laws"?

Use Kirchhoff's current and voltage laws to solve circuits that are not simple series or parallel.