Tools / Loaded Voltage Divider

How to work out a loaded voltage divider

A load sits in parallel with the bottom resistor and pulls the output down. Here is how much, with your numbers.

Vout = Vin × (R2 ∥ RL) / (R1 + (R2 ∥ RL))

Inputs

V
Ω
Ω
Ω

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Loaded output
2.381 V
Effective lower
9.091 kΩ
What this leaves out
  • Static ideal resistive load only; dissipations, source loading and tolerance must be checked separately.
Step by step

The working with your numbers

  1. Without the loadVout = Vin × R2 ÷ (R1 + R2) = 5 × 10,000 ÷ 20,000 = 2.5 V
  2. Combine R2 and the load in parallelR2 ∥ RL = (R2 × RL) ÷ (R2 + RL) = (10,000 × 100,000) ÷ 110,000 = 9.09 kΩ
  3. Use the divider rule with the new bottom resistanceVout = 5 × 9,091 ÷ (10,000 + 9,091) = 2.38 V
  4. How much the load pulled it down2.5 V → 2.38 V, a drop of 4.76 %

Does the answer make sense?

  • OK: The load is 20 times the divider's own resistance (5 kΩ), so the output only drops a little.

Pick a real part

  • For an output within about 10 % of the unloaded value, the load should be at least 50 kΩ.

Common mistakes

  • Using the unloaded formula when something is connected. A 10 kΩ load on a 10 kΩ + 10 kΩ divider turns 2.5 V into about 1.7 V.
  • Making the divider resistors smaller to fix loading without checking the current they then waste.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Just need the number? Use the loaded voltage divider calculator on Geekobot.

Common questions

What does loading a voltage divider mean?

Connecting anything to the output puts its resistance in parallel with the bottom resistor. The bottom resistance falls, so the output voltage falls too.

How big should the load be on a voltage divider?

At least ten times R1 in parallel with R2. Then the output stays within about 10 % of the unloaded value.