Lab / Virtual lab / DC circuits

Superposition theorem

Show that the current in a branch with two sources equals the sum of the currents from each source acting alone.

DC circuitsSimulatedFull experiment write-up →

Circuit

Updates as you change values
10 VR1 1 kΩR32.2 kΩAR2 1 kΩ5 V

V1 through R1 = 1 kΩ and V2 through R2 = 1 kΩ both feed R3 = 2.2 kΩ; switch off one source at a time (replace it with a short) and read I3.

Controls

Changing any setting except v1 or sources starts a new set of readings. Changing sources keeps them, so you can compare curves.

Meters

I32.78 mA

Graph

0 readings

Your graph appears here

Take readings, or press Auto sweep to log a full set.

your readings other sources

Theory

  • Node voltage VN = (V1/R1 + V2/R2) / (1/R1 + 1/R2 + 1/R3)
  • I3 = VN / R3
  • Superposition: I3 = I3′ (V1 alone) + I3″ (V2 alone)
  • Turn a voltage source off by shorting it; a current source by opening it
  • Works for currents and voltages, not power (P ∝ I²)

Worked out for your values

I3′ (V1 alone)
1.852 mA
I3″ (V2 alone)
925.9 µA
I3 (both)
2.778 mA
Power in R3 (both)
16.98 mW

Your result

Worked out from your readings and compared with theory.

I3′ + I3″ against I3 (both on)

At one V1 setting, take a reading with both sources, V1 only and V2 only.

Sources of error

  • A real source has internal resistance, so shorting it is not quite the same as removing it
  • Meter rounding adds up when two readings are summed
  • Supply drift between the three readings