Lab / Virtual lab / Diodes and power supplies

Biased diode clipper

Plot the transfer characteristic of a clipper and see the output flatten at the bias voltage plus one diode drop.

Diodes and power suppliesSimulated

Circuit

Updates as you change values
VinR 1 kΩ1N4148Vbias 0 V

A 1 kΩ series resistor, then a diode to a bias battery; read the output for input voltages from −10 V to +10 V.

Controls

Changing any setting except input voltage starts a new set of readings.

Meters

Output0 V

Graph

0 readings

Your graph appears here

Take readings, or press Auto sweep to log a full set.

your readings

Theory

  • Diode off (VIN below VB + 0.6 V): VO = VIN
  • Diode on: VO ≈ VB + VD, with VD about 0.6–0.7 V
  • Peak clip level VB + VD limits the output however large the input
  • Reverse the diode to clip the negative half instead
  • Series resistor R limits the diode current: ID = (VIN − VO) / R

Worked out for your values

Clip level at 10 V in
753.7 mV
Diode drop VD
753.7 mV
Output now
0 V
Peak diode current at 10 V in
9.246 mA

Your result

Worked out from your readings and compared with theory.

Clip level (highest output)

Take readings up to 10 V input.

Gain below clipping (slope for VIN < 0)

Take two or more readings below −1 V.

Sources of error

  • The diode drop rises with current, so the 'flat' top still creeps up
  • Silicon diode starts conducting gradually, rounding the knee
  • A real battery bias sags with load