Lab / Virtual lab / Diodes and power supplies

Diode clamper

Show that a clamper shifts a signal up or down without changing its shape, and measure the DC level it adds.

Diodes and power suppliesSimulated

Circuit

Updates as you change values
2 V pkC 10 µF1N4148Vbias 0 V

A 5 V peak sine through a capacitor into a diode to ground, with a bias battery; read the negative and positive peaks of the output.

Controls

Changing any setting except input peak voltage starts a new set of readings.

Meters

Output negative peak-0.65 V
Output positive peak3.35 V

Graph

0 readings

Your graph appears here

Take readings, or press Auto sweep to log a full set.

your readings

Theory

  • The diode conducts on the negative peaks and charges the capacitor to VC = VP − VD + VB
  • Output = input + VC, so the whole waveform is shifted up
  • Negative peak is clamped to VB − VD (about VB − 0.65 V)
  • Positive peak = VB − VD + 2 VP; the peak-to-peak swing stays 2 VP
  • Time constant R C must be much longer than the signal period or the level droops

Worked out for your values

Clamped bottom level
-650 mV
Capacitor charge VC
1.35 V
Output positive peak
3.35 V
Peak-to-peak swing
4 V

Your result

Worked out from your readings and compared with theory.

Peak-to-peak swing kept (slope of positive peak against VP is 2)

Take two or more readings at different input peaks.

Negative peak clamp level

Take a reading.

Sources of error

  • Diode forward drop sets the clamp level a little below the bias
  • A load resistor discharges the capacitor between peaks, so the level droops
  • Use a long R C compared with the signal period