RS485 to TTL module (MAX485)
RS-485 transceiver board for Modbus sensors.
What is the RS485 to TTL module (MAX485) and what is it used for?
RS-485 transceiver board for Modbus sensors. Makers use it for modbus sensors and long cables.
A MAX485 turns UART logic into a differential pair that runs reliably over hundreds of metres.
Key specifications
| Interface module spec | Value |
|---|---|
| Function | Half-duplex RS-485 |
| Supply voltage | 5 V |
| Interface | DI, RO, DE, RE |
| Logic level | 5 V |
Pinout
How to use it
Tie DE and RE together to one pin: high to send, low to receive. Use the ModbusMaster library for Modbus RTU sensors. Keep the 120 Ω terminator only on the two end nodes.
Applications
Builds that use it
Alternatives
- RS485 to TTL auto-direction moduleNo direction pin needed
- USB to RS485 adapterConnect from a PC
Common questions
What is the RS485 to TTL module (MAX485) used for?
In maker projects: modbus sensors and long cables.
How does the RS485 to TTL module (MAX485) work?
A MAX485 turns UART logic into a differential pair that runs reliably over hundreds of metres.
What voltage does the RS485 to TTL module (MAX485) need?
5 V.
How do I connect the RS485 to TTL module (MAX485) to an Arduino or ESP32?
DI, RO, DE, RE. Pins: RO (Receiver out (to RX)), RE (Receiver enable (low)), DE (Driver enable (high)), DI (Driver in (from TX)), VCC GND (5 V), A B (RS-485 pair).
What can I use instead of the RS485 to TTL module (MAX485)?
RS485 to TTL auto-direction module and USB to RS485 adapter.
