Idea
In short
How do you build an RS-485 two-board sensor line?
A sensor board sends readings over twisted wire to a display board across a room. You need Arduino Uno R3 × 2, RS485 to TTL module (MAX485) × 2, DHT22 Sensor, SSD1306 OLED Display, Resistor 10 kΩ and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Understand differential serial links.
Parts list
- Development BoardsArduino Uno R3 × 2
- Interfaces
- Sensors
- Displays
- Passives
- Prototyping
How to build it
- Wire two MAX485 modules
- Set direction control
- Poll the sensor
- Show the reading
- Add a checksum and timeout
Common questions
What parts do I need for the RS-485 two-board sensor line?
Arduino Uno R3 × 2, RS485 to TTL module (MAX485) × 2, DHT22 Sensor, SSD1306 OLED Display, Resistor 10 kΩ and Breadboard 830 Tie Points.
How long does the RS-485 two-board sensor line take to build?
About 240 minutes for a intermediate maker.
