Components / Wireless / LoRa SX1278 Ra-02 module (433 MHz)

LoRa SX1278 Ra-02 module (433 MHz)

SX1278 LoRa module for 433 MHz.

RadioLoRa
Band433 MHz
Typical rangeSeveral km line of sight
InterfaceSPI
WirelessReviewedMPN Ra-02Used in 2 projects
SX1278
In short

What is the LoRa SX1278 Ra-02 module (433 MHz) and what is it used for?

SX1278 LoRa module for 433 MHz. Makers use it for long-range telemetry where 433 MHz is allowed.

How it works

A Semtech SX1278 chirp spread-spectrum radio that trades data rate for range, reaching kilometres at a few kbps.

Key specifications

Wireless module specValue
RadioLoRa
Band433 MHz
Typical rangeSeveral km line of sight
InterfaceSPI
Supply voltage3.3 V
Watch out forIn India use 865 to 867 MHz for licence-free LoRa

Pinout

3.3V3.3 V only
GNDGround
NSSSPI chip select
SCK MOSI MISOSPI
RSTReset
DIO0Interrupt for TX done and RX done
IPEXAntenna connector

How to use it

The pads are not on a 2.54 mm grid, so solder it to an adapter board. Use the LoRa library with LoRa.setPins(ss, reset, dio0) and LoRa.begin(433E6). Always connect an antenna before transmitting.

Applications

Alternatives

Buy at

Common questions

What is the LoRa SX1278 Ra-02 module (433 MHz) used for?

In maker projects: long-range telemetry where 433 MHz is allowed.

How does the LoRa SX1278 Ra-02 module (433 MHz) work?

A Semtech SX1278 chirp spread-spectrum radio that trades data rate for range, reaching kilometres at a few kbps.

What voltage does the LoRa SX1278 Ra-02 module (433 MHz) need?

3.3 V.

How do I connect the LoRa SX1278 Ra-02 module (433 MHz) to an Arduino or ESP32?

SPI. Pins: 3.3V (3.3 V only), GND (Ground), NSS (SPI chip select), SCK MOSI MISO (SPI), RST (Reset), DIO0 (Interrupt for TX done and RX done).

What can I use instead of the LoRa SX1278 Ra-02 module (433 MHz)?

RFM95W LoRa module (868 MHz) and E32 LoRa UART module (868 MHz).