BNO055 absolute orientation sensor
9-axis IMU with a built-in processor that outputs ready-made orientation.
What is the BNO055 absolute orientation sensor and what is it used for?
9-axis IMU with a built-in processor that outputs ready-made orientation. Makers use it for robot heading, VR demos.
An accelerometer, gyroscope and magnetometer with an on-chip processor that runs sensor fusion and outputs orientation.
Key specifications
| Sensor spec | Value |
|---|---|
| Measures | Orientation (quaternion, Euler), acceleration, rotation, magnetic field |
| Interface | I2C or UART |
| I2C address | 0x28 or 0x29 |
| Supply voltage | 2.4 to 3.6 V |
Pinout
How to use it
Use the Adafruit BNO055 library. Move the sensor through a figure of eight and different angles until all calibration values reach 3, then save the offsets. It uses I2C clock stretching, which some boards handle poorly; slow the bus if readings fail.
Applications
Builds that use it
Alternatives
- MPU6050 IMUCheaper, fusion done in your code
- ICM-20948 9-axis IMURaw 9-axis data for your own fusion
Common questions
What is the BNO055 absolute orientation sensor used for?
In maker projects: robot heading, VR demos.
How does the BNO055 absolute orientation sensor work?
An accelerometer, gyroscope and magnetometer with an on-chip processor that runs sensor fusion and outputs orientation.
What voltage does the BNO055 absolute orientation sensor need?
2.4 to 3.6 V.
How do I connect the BNO055 absolute orientation sensor to an Arduino or ESP32?
I2C or UART. Pins: VIN (3.3 to 5 V on modules), GND (Ground), SDA (I2C data or UART RX), SCL (I2C clock or UART TX), RST (Reset, active low), INT (Interrupt).
What can I use instead of the BNO055 absolute orientation sensor?
MPU6050 IMU and ICM-20948 9-axis IMU.
