Projects / Ideas / Nucleo orientation readout

Nucleo orientation readout

AdvancedMotionIdeaReviewed
In short

How do you build a nucleo orientation readout?

A Nucleo-64 board reads a BNO055 absolute orientation sensor and shows heading, pitch and roll on an OLED, with a calibration status line. You need STM32 Nucleo-64, BNO055 absolute orientation sensor, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Advanced
Time
About 190 min
Parts
4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Read the angle of a board in space.

How to build it

  1. Wire the sensor and display on I2C
  2. Check the calibration status
  3. Read the Euler angles
  4. Show heading, pitch and roll
  5. Wait for full calibration

Related projects

Common questions

What parts do I need for the nucleo orientation readout?

STM32 Nucleo-64, BNO055 absolute orientation sensor, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the nucleo orientation readout take to build?

About 190 minutes for a advanced maker.