7-segment display 1 digit (common cathode)
Single 0.56 inch red digit. Each segment needs a resistor.
TypeLED 7-segment
Size0.56 inch digit
Driver ICNone (drive segments directly or with a 74HC595)
Interface8 pins (7 segments + dot) plus common
DisplaysReviewedMPN 5161ASUsed in 12 projects
In short
What is the 7-segment display 1 digit (common cathode) and what is it used for?
Single 0.56 inch red digit. Each segment needs a resistor. Makers use it for counters, dice.
How it works
Eight LEDs shaped as segments share one cathode, and lighting a set of them forms a digit.
Key specifications
| Display spec | Value |
|---|---|
| Type | LED 7-segment |
| Size | 0.56 inch digit |
| Driver IC | None (drive segments directly or with a 74HC595) |
| Interface | 8 pins (7 segments + dot) plus common |
| Supply voltage | About 2 V per segment, 10 to 20 mA |
Pinout
1e
2d
3Common cathode
4c
5DP
6b
7a
8Common cathode
9f
10g
How to use it
Connect common to GND and each segment through its own 220 Ω to 330 Ω resistor. A 74HC595 or CD4511 cuts the pins needed.
Applications
Countersdice
Builds that use it
Guided build
Electronic Ludo dice
Guided build
Hand-programmed EEPROM lookup table
Guided build
BCD switch to display
Guided build
4-bit binary adder with display
Guided build
Electronic dice
Guided build
Seven-segment direct drive test
Guided build
Electronic dice with a 7-segment display
Idea
Two-digit counter with display
Showing 8 of 12
Alternatives
- 7-segment display 4 digit (common cathode)Four digits
- TM1637 4-digit displayFour digits with a 2-wire driver
Common questions
What is the 7-segment display 1 digit (common cathode) used for?
In maker projects: counters, dice.
How does the 7-segment display 1 digit (common cathode) work?
Eight LEDs shaped as segments share one cathode, and lighting a set of them forms a digit.
What voltage does the 7-segment display 1 digit (common cathode) need?
About 2 V per segment, 10 to 20 mA.
How do I connect the 7-segment display 1 digit (common cathode) to an Arduino or ESP32?
8 pins (7 segments + dot) plus common. Pins: 1 (e), 2 (d), 3 (Common cathode), 4 (c), 5 (DP), 6 (b).
What can I use instead of the 7-segment display 1 digit (common cathode)?
7-segment display 4 digit (common cathode) and TM1637 4-digit display.
