Idea
In short
How do you build a bare WS2811 three-LED driver?
A single WS2811 driver chip on a breadboard sets the colour of one red, one green and one blue LED from a one-wire stream sent by a Nano. You need Arduino Nano, WS2811 LED driver IC, LED 5 mm red, LED 5 mm green, LED 5 mm blue, Resistor 220 Ω × 3, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Drive a bare serial LED driver chip.
Parts list
- Development Boards
- Integrated Circuits
- Semiconductors
- Semiconductors
- Optoelectronics
- PassivesResistor 220 Ω × 3
- Power
- Prototyping
How to build it
- Check which supply version your chip is
- Wire the three LEDs to the outputs with resistors
- Send the data stream at the WS2811 speed
- Set each colour level
- Compare with a WS2812B pixel
Common questions
What parts do I need for the bare WS2811 three-LED driver?
Arduino Nano, WS2811 LED driver IC, LED 5 mm red, LED 5 mm green, LED 5 mm blue, Resistor 220 Ω × 3, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
How long does the bare WS2811 three-LED driver take to build?
About 150 minutes for a intermediate maker.
