Idea
In short
How do you build a sixteen-LED chaser over I2C?
A 16-pin expander drives sixteen LEDs with just two wires from the board, running chase patterns. You need Arduino Nano, MCP23017 I/O expander module, LED 5 mm green × 8, LED 5 mm red × 8, Resistor 330 Ω × 16 and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 150 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Add 16 outputs over I2C.
Parts list
- Development Boards
- Interfaces
- SemiconductorsLED 5 mm green × 8
- SemiconductorsLED 5 mm red × 8
- PassivesResistor 330 Ω × 16
- Prototyping
How to build it
- Set the address pins
- Wire all sixteen LEDs
- Set the pins as outputs
- Run a chase
- Add a pattern button
Common questions
What parts do I need for the sixteen-LED chaser over I2C?
Arduino Nano, MCP23017 I/O expander module, LED 5 mm green × 8, LED 5 mm red × 8, Resistor 330 Ω × 16 and Breadboard 830 Tie Points.
How long does the sixteen-LED chaser over I2C take to build?
About 150 minutes for a beginner maker.
