Projects / Ideas / Wobble board trainer

Wobble board trainer

IntermediateLearningIdeaReviewed
In short

How do you build a wobble board trainer?

A motion sensor under a round wobble board shows how long you stay near level and traces your wobble on a screen as you balance. Try to hold a smaller and smaller circle. Use a low board, a mat and something to hold, and do not use it where a fall could hurt. You need Arduino Nano, MPU6050 IMU, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 90 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Trace and score your balance on a wobble board.

How to build it

  1. Fix the sensor under the board
  2. Read the tilt in two directions
  3. Plot the position as a dot on the screen
  4. Time how long it stays in a small circle
  5. Show the best time

Related projects

Common questions

What parts do I need for the wobble board trainer?

Arduino Nano, MPU6050 IMU, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the wobble board trainer take to build?

About 90 minutes for a intermediate maker.