Projects / Ideas / Flywheel spin-down lab

Flywheel spin-down lab

IntermediateLearningIdeaReviewed
In short

How do you build a flywheel spin-down lab?

A small motor spins up a light flywheel, then is switched off and a reflective sensor times how the speed falls away. Compare flywheels of different size and see why a heavier wheel keeps going longer. Use a guard around the wheel, keep it small and light, and keep hair and sleeves clear. You need Arduino Nano, DC motor 130 size (toy motor), MOSFET IRLZ44N, Signal Diode 1N4148, TCRT5000 IR reflective sensor module, SSD1306 OLED Display, Tactile push button 6 mm, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
11
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Time how a flywheel slows down.

How to build it

  1. Spin the flywheel with a MOSFET switch
  2. Add a diode across the motor
  3. Mark the wheel for the sensor
  4. Log speed against time after switch-off
  5. Compare a light and a heavier wheel

Related projects

Common questions

What parts do I need for the flywheel spin-down lab?

Arduino Nano, DC motor 130 size (toy motor), MOSFET IRLZ44N, Signal Diode 1N4148, TCRT5000 IR reflective sensor module, SSD1306 OLED Display, Tactile push button 6 mm, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the flywheel spin-down lab take to build?

About 100 minutes for a intermediate maker.