Projects / Ideas / Wheatstone bridge thermometer

Wheatstone bridge thermometer

IntermediateAnalog CircuitsIdeaReviewed
In short

How do you build a wheatstone bridge thermometer?

An NTC thermistor, a trimmer and two fixed resistors form a Wheatstone bridge, and an LM358 amplifies the small difference so a multimeter reads a voltage that follows temperature. A classic way to measure small changes. You need NTC thermistor 10 kΩ (B3950), Trimmer potentiometer 10 kΩ (3296), LM358 Op-Amp, Resistor 10 kΩ × 3, Resistor 100 kΩ × 2, 9 V battery snap with DC jack and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 160 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Measure temperature with a bridge and an amplifier.

How to build it

  1. Build the bridge
  2. Balance it with the trimmer at room temperature
  3. Add the op-amp gain stage
  4. Warm the thermistor
  5. Read the output voltage

Related projects

Common questions

What parts do I need for the wheatstone bridge thermometer?

NTC thermistor 10 kΩ (B3950), Trimmer potentiometer 10 kΩ (3296), LM358 Op-Amp, Resistor 10 kΩ × 3, Resistor 100 kΩ × 2, 9 V battery snap with DC jack and Breadboard 830 Tie Points.

How long does the wheatstone bridge thermometer take to build?

About 160 minutes for a intermediate maker.