Projects / Ideas / Adjustable gain amplifier

Adjustable gain amplifier

IntermediateAnalog CircuitsIdeaReviewed
In short

How do you build an adjustable gain amplifier?

A single op-amp stage with a gain knob amplifies a small signal, a good way to learn gain and clipping. You need LM358 Op-Amp, Potentiometer 10 kΩ, Resistor 10 kΩ × 2, Resistor 100 kΩ, Ceramic Capacitor 100 nF, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 210 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Learn op-amp gain by building it.

How to build it

  1. Wire a non-inverting stage
  2. Bias at half the supply
  3. Feed a small signal
  4. Vary the gain
  5. Watch it clip near the rails

Related projects

Common questions

What parts do I need for the adjustable gain amplifier?

LM358 Op-Amp, Potentiometer 10 kΩ, Resistor 10 kΩ × 2, Resistor 100 kΩ, Ceramic Capacitor 100 nF, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.

How long does the adjustable gain amplifier take to build?

About 210 minutes for a intermediate maker.