Projects / Ideas / Solar water heater backup controller

Solar water heater backup controller

IntermediateSmart HomeIdeaReviewed
In short

How do you build a solar water heater backup controller?

A probe in the solar water heater tank switches on the electric backup only if the water is below 40 °C at 6 am, saving power on sunny days. You need Arduino Nano, DS18B20 waterproof probe, Resistor 4.7 kΩ, DS3231 RTC module, Solid state relay SSR-40DA and 16x2 LCD with I2C backpack (PCF8574).

Level
Intermediate
Time
About 120 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Combine a time and a temperature condition to control a heater.

How to build it

  1. Fit the probe in the tank's sensor pocket
  2. At 6 am, check the temperature
  3. Run the backup heater until 45 °C or 7 am
  4. Show the tank temperature all day
  5. A qualified electrician wires the SSR and the heater

Related projects

Common questions

What parts do I need for the solar water heater backup controller?

Arduino Nano, DS18B20 waterproof probe, Resistor 4.7 kΩ, DS3231 RTC module, Solid state relay SSR-40DA and 16x2 LCD with I2C backpack (PCF8574).

How long does the solar water heater backup controller take to build?

About 120 minutes for a intermediate maker.