Idea
In short
How do you build a poultry brooder temperature controller?
A DS18B20 keeps chicks warm by switching an infrared bulb through a solid-state relay, stepping the set point down each week as they grow. You need Arduino Nano, DS18B20 waterproof probe, Resistor 4.7 kΩ, Solid state relay SSR-40DA, DS3231 RTC module, 16x2 LCD with I2C backpack (PCF8574), Active buzzer 5 V and ABS project box (100 × 60 × 25 mm).
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Control a heater with a set point that changes on a schedule.
Parts list
- Development Boards
- Sensors
- Passives
- Switches
- Sensors
- Displays
- Motors & Actuators
- Mechanical & Hardware
How to build it
- Hang the probe at chick height under the lamp
- Start at 33 °C and drop 3 °C each week from the start date
- Switch the lamp with the SSR with 0.5 °C hysteresis
- Beep if it goes 3 °C above or below
- Mains wiring must be enclosed and done by a qualified person
Common questions
What parts do I need for the poultry brooder temperature controller?
Arduino Nano, DS18B20 waterproof probe, Resistor 4.7 kΩ, Solid state relay SSR-40DA, DS3231 RTC module, 16x2 LCD with I2C backpack (PCF8574), Active buzzer 5 V and ABS project box (100 × 60 × 25 mm).
How long does the poultry brooder temperature controller take to build?
About 150 minutes for a intermediate maker.
