Idea
In short
How do you build a bottle filler with a flow sensor?
A flow sensor counts pulses to measure litres, and a pump switches off at a set volume. You need Arduino Nano, Water flow sensor YF-S201, Mini submersible water pump (3 to 6 V), NPN Transistor 2N2222, Resistor 1 kΩ, Rectifier Diode 1N4007, Tactile push button 6 mm, SSD1306 OLED Display and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 300 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Dispense a set amount of water.
Parts list
- Development Boards
- Sensors
- Motors & Actuators
- Semiconductors
- Passives
- Semiconductors
- Switches
- Displays
- Prototyping
How to build it
- Count flow pulses
- Calibrate pulses per litre
- Wire the pump driver
- Stop at a set volume
- Show the volume
Related projects
Common questions
What parts do I need for the bottle filler with a flow sensor?
Arduino Nano, Water flow sensor YF-S201, Mini submersible water pump (3 to 6 V), NPN Transistor 2N2222, Resistor 1 kΩ, Rectifier Diode 1N4007, Tactile push button 6 mm, SSD1306 OLED Display and Breadboard 830 Tie Points.
How long does the bottle filler with a flow sensor take to build?
About 300 minutes for a intermediate maker.
