Idea
In short
How do you build a cupboard safe tamper alarm?
A vibration sensor and a tilt switch inside a cupboard safe sound an alarm if someone tries to drill, shake or lift it. You need Arduino Nano, Vibration sensor module (SW-420), Tilt sensor (ball switch, SW-520D), Active buzzer 5 V, 4x4 matrix keypad (membrane), Battery holder 4 × AA with switch and AA alkaline battery × 4.
- Level
- Beginner
- Time
- About 120 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Combine two simple sensors with an arming delay.
Parts list
- Development Boards
- Sensors
- Sensors
- Motors & Actuators
- Switches
- Power
- Batteries
How to build it
- Fit both sensors inside the safe
- Arm with a code on the keypad and allow 30 s to close it
- Count vibration pulses: more than 5 in 2 s means tampering
- Sound the alarm on tamper or tilt
- Disarm with the code
Common questions
What parts do I need for the cupboard safe tamper alarm?
Arduino Nano, Vibration sensor module (SW-420), Tilt sensor (ball switch, SW-520D), Active buzzer 5 V, 4x4 matrix keypad (membrane), Battery holder 4 × AA with switch and AA alkaline battery × 4.
How long does the cupboard safe tamper alarm take to build?
About 120 minutes for a beginner maker.
