Idea
In short
How do you build a latching alarm with an SCR?
A thyristor latches on after a brief trigger and stays on until the power is removed, a classic simple alarm. Low voltage only, never mains. You need TYN612 SCR, Tactile push button 6 mm × 2, Resistor 1 kΩ, Resistor 10 kΩ, Passive buzzer, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn how an SCR latches.
Parts list
- Semiconductors
- Switches
- Passives
- Passives
- Motors & Actuators
- Batteries
- Power
- Prototyping
How to build it
- Draw the gate trigger
- Wire the SCR in series with the buzzer
- Press the trigger button
- See it latch
- Reset by breaking the supply
Common questions
What parts do I need for the latching alarm with an SCR?
TYN612 SCR, Tactile push button 6 mm × 2, Resistor 1 kΩ, Resistor 10 kΩ, Passive buzzer, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the latching alarm with an SCR take to build?
About 120 minutes for a intermediate maker.
