Idea
In short
How do you build a power push-pull stage?
A matched pair of power transistors drive a small speaker from a tone source, and you see crossover distortion on a scope. You need TIP41C NPN power transistor, TIP42C PNP power transistor, Resistor 1 kΩ × 2, Potentiometer 10 kΩ, Speaker 8 Ω 0.5 W, Electrolytic Capacitor 100 µF, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 270 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a power push-pull stage.
Parts list
- Semiconductors
- Semiconductors
- PassivesResistor 1 kΩ × 2
- Passives
- Motors & Actuators
- Passives
- Batteries
- Power
- Prototyping
How to build it
- Bias both transistors
- Add the coupling capacitor
- Feed a tone
- Watch the crossover on a scope
- Add a bias fix
Common questions
What parts do I need for the power push-pull stage?
TIP41C NPN power transistor, TIP42C PNP power transistor, Resistor 1 kΩ × 2, Potentiometer 10 kΩ, Speaker 8 Ω 0.5 W, Electrolytic Capacitor 100 µF, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the power push-pull stage take to build?
About 270 minutes for a intermediate maker.
