Idea
In short
How do you build a darlington fan driver?
A Darlington transistor switches a small 5 V fan from a board pin, with a diode across the fan and a knob for the speed. You need Arduino Nano, TIP122 Darlington transistor, 5 V DC fan 40 mm, 1N4001 rectifier diode, Resistor 1 kΩ, Potentiometer 10 kΩ and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 120 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Switch a small load with a Darlington.
Parts list
- Development Boards
- Semiconductors
- Motors & Actuators
- Semiconductors
- Passives
- Passives
- Prototyping
How to build it
- Read how a Darlington pair gives high gain
- Add the base resistor
- Add the flyback diode across the fan
- Drive it with PWM
- Measure the voltage lost across the transistor
Common questions
What parts do I need for the darlington fan driver?
Arduino Nano, TIP122 Darlington transistor, 5 V DC fan 40 mm, 1N4001 rectifier diode, Resistor 1 kΩ, Potentiometer 10 kΩ and Breadboard 830 Tie Points.
How long does the darlington fan driver take to build?
About 120 minutes for a beginner maker.
