Idea
In short
How do you build a p-channel high-side load switch?
A P-channel MOSFET switches a 12 V lamp or fan on the positive side with a pull-up and a small NPN, keeping the load ground fixed. You need Arduino Nano, IRF9Z34N P-channel MOSFET, Resistor 10 kΩ × 2, Resistor 1 kΩ, 5 V DC fan 40 mm, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use a P-channel as a load switch.
Parts list
- Development Boards
- Semiconductors
- PassivesResistor 10 kΩ × 2
- Passives
- Motors & Actuators
- Batteries
- Power
- Prototyping
How to build it
- Draw the gate drive
- Keep the gate within its limit
- Add the NPN pull-down
- Switch the fan
- Measure the voltage across the switch
Common questions
What parts do I need for the p-channel high-side load switch?
Arduino Nano, IRF9Z34N P-channel MOSFET, Resistor 10 kΩ × 2, Resistor 1 kΩ, 5 V DC fan 40 mm, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the p-channel high-side load switch take to build?
About 150 minutes for a intermediate maker.
