Idea
In short
How do you build a darlington driver for a small lamp?
A Darlington transistor lets a small board pin switch a bigger 12 V LED strip piece. Learn base resistors and heat. You need Arduino Nano, TIP120 Darlington transistor, Resistor 1 kΩ, Rectifier Diode 1N4007, 12 V LED strip warm white (5 m, 2835), 12 V 2 A DC adapter and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 180 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Switch a load with a Darlington.
Parts list
- Development Boards
- Semiconductors
- Passives
- Semiconductors
- Optoelectronics
- Power
- Prototyping
How to build it
- Choose a base resistor
- Wire the load side
- Add a flyback diode for motors later
- Switch on a command
- Measure the voltage drop
Common questions
What parts do I need for the darlington driver for a small lamp?
Arduino Nano, TIP120 Darlington transistor, Resistor 1 kΩ, Rectifier Diode 1N4007, 12 V LED strip warm white (5 m, 2835), 12 V 2 A DC adapter and Breadboard 830 Tie Points.
How long does the darlington driver for a small lamp take to build?
About 180 minutes for a beginner maker.
