Projects / Ideas / Supercapacitor self-discharge test

Supercapacitor self-discharge test

BeginnerPowerIdeaReviewed
In short

How do you build a supercapacitor self-discharge test?

Charge a 1 F and a 10 F supercapacitor to a safe voltage, then log how it drops over a day with a multimeter. You see how a supercapacitor slowly loses charge, and why it is not a battery. You need Supercapacitor 5.5 V 1 F, Supercapacitor 2.7 V 10 F, Resistor 100 Ω, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 45 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Watch a supercapacitor leak charge over a day.

How to build it

  1. Charge the 1 F cap through a resistor to a safe value below its rating
  2. Note the start time and voltage
  3. Check every few hours for a day
  4. Repeat with the 10 F cap
  5. Plot both curves and write down the rate

Related projects

Common questions

What parts do I need for the supercapacitor self-discharge test?

Supercapacitor 5.5 V 1 F, Supercapacitor 2.7 V 10 F, Resistor 100 Ω, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the supercapacitor self-discharge test take to build?

About 45 minutes for a beginner maker.