Idea
In short
How do you build an enamelled wire stripping practice?
Enamelled magnet wire has to be stripped before it can be soldered. Try scraping, sanding and burning off the coating on short lengths, then tin each and check the joint. You learn which method is clean and repeatable. Do the burning in a ventilated place. You need Enamelled copper wire (magnet wire, 0.3 mm), Soldering iron 60 W (adjustable temperature), Solder wire 60/40 (0.8 mm, 50 g), Soldering flux paste, Wire stripper and cutter and Tweezers set (ESD safe).
- Level
- Beginner
- Time
- About 45 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn to solder enamelled wire.
Parts list
- Cables & Wires
- Tools & Instruments
- Tools & Instruments
- Tools & Instruments
- Tools & Instruments
- Tools & Instruments
How to build it
- Cut six short lengths
- Strip two by scraping, two by sanding, two by heat
- Tin each end
- Solder to a pad
- Test continuity with a meter
Common questions
What parts do I need for the enamelled wire stripping practice?
Enamelled copper wire (magnet wire, 0.3 mm), Soldering iron 60 W (adjustable temperature), Solder wire 60/40 (0.8 mm, 50 g), Soldering flux paste, Wire stripper and cutter and Tweezers set (ESD safe).
How long does the enamelled wire stripping practice take to build?
About 45 minutes for a beginner maker.
