Idea
In short
How do you build a soldering iron tip care lab?
Compare how well solder flows from an iron tip that is clean and freshly tinned with one that is dirty, and see how a few seconds of tip care makes joints better and the tip last longer. The iron is hot, so always put it in its stand. You need Soldering iron 60 W (adjustable temperature), Soldering stand with sponge, Solder wire 60/40 (0.8 mm, 50 g) and Soldering flux paste.
- Level
- Beginner
- Time
- About 40 min
- Parts
- 4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn to keep a soldering tip clean and tinned.
Parts list
- Tools & Instruments
- Tools & Instruments
- Tools & Instruments
- Tools & Instruments
How to build it
- Heat the iron and look at a dirty tip
- Wipe and tin it
- Time how long a joint takes with each
- Compare how the solder flows
- Tin the tip again before putting it away
Common questions
What parts do I need for the soldering iron tip care lab?
Soldering iron 60 W (adjustable temperature), Soldering stand with sponge, Solder wire 60/40 (0.8 mm, 50 g) and Soldering flux paste.
How long does the soldering iron tip care lab take to build?
About 40 minutes for a beginner maker.
