Projects / Ideas / Etch design-rule test strip

Etch design-rule test strip

IntermediateHome LabIdeaReviewed
In short

How do you build an etch design-rule test strip?

Make a small test board with lines and gaps from wide to very narrow, etch it by your usual method, and see which widths survive. You learn the limits of your own process so the real boards you design will work. Wear gloves and goggles with etchant and follow the safety steps from the etching guide. You need Copper clad board (single side) 10 × 15 cm, Ferric chloride (PCB etchant), Isopropyl alcohol 99 % (flux cleaner) and USB microscope.

Level
Intermediate
Time
About 120 min
Parts
4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Find the thinnest trace your process can make.

How to build it

  1. Draw a pattern of lines and gaps
  2. Transfer it to the copper
  3. Etch with care
  4. Look at each line under the microscope
  5. Write your own minimum trace and gap

Related projects

Common questions

What parts do I need for the etch design-rule test strip?

Copper clad board (single side) 10 × 15 cm, Ferric chloride (PCB etchant), Isopropyl alcohol 99 % (flux cleaner) and USB microscope.

How long does the etch design-rule test strip take to build?

About 120 minutes for a intermediate maker.