Idea
In short
How do you build a smart charger for AA NiMH cells?
An Arduino charges two NiMH cells at constant current and stops on the tiny voltage drop (−ΔV) that marks full charge. You need Arduino Nano, MOSFET IRLZ44N, Resistor 10 Ω, Battery holder 2 × AA, AA NiMH rechargeable 2000 mAh × 2, DS18B20 Temperature Sensor, Resistor 4.7 kΩ and SSD1306 OLED Display.
- Level
- Advanced
- Time
- About 240 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Detect end of charge from a voltage signature.
Parts list
- Development Boards
- Semiconductors
- Passives
- Power
- Batteries
- Sensors
- Passives
- Displays
How to build it
- Charge through a resistor and MOSFET at about 0.5 C
- Measure cell voltage with the charger briefly off
- Track the peak voltage
- Stop when it falls 5 mV per cell below the peak or the cells get warm
- Add a timer limit for safety
Common questions
What parts do I need for the smart charger for AA NiMH cells?
Arduino Nano, MOSFET IRLZ44N, Resistor 10 Ω, Battery holder 2 × AA, AA NiMH rechargeable 2000 mAh × 2, DS18B20 Temperature Sensor, Resistor 4.7 kΩ and SSD1306 OLED Display.
How long does the smart charger for AA NiMH cells take to build?
About 240 minutes for a advanced maker.
