Projects / Ideas / NiMH capacity tester

NiMH capacity tester

IntermediatePowerIdeaReviewed
In short

How do you build a niMH capacity tester?

A small load drains one rechargeable AA cell while the board logs the voltage and adds up the milliamp-hours until it reaches a safe cut-off. You need Arduino Nano, AA NiMH rechargeable 2000 mAh, 2N7000 N-channel MOSFET, Resistor 10 Ω, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 300 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Measure cell capacity.

How to build it

  1. Wire the load switch
  2. Read the cell voltage
  3. Add up the current over time
  4. Stop at 1.0 V
  5. Compare with the label

Related projects

Common questions

What parts do I need for the niMH capacity tester?

Arduino Nano, AA NiMH rechargeable 2000 mAh, 2N7000 N-channel MOSFET, Resistor 10 Ω, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the niMH capacity tester take to build?

About 300 minutes for a intermediate maker.