Idea
In short
How do you build a two-channel fader mixer?
Two slide pots mix two audio sources into one small speaker, a simple look at volume faders. You need Slide potentiometer 10 kΩ × 2, LM386 amplifier module, Speaker 8 Ω 0.5 W, Resistor 10 kΩ × 2, Electrolytic capacitor 10 µF × 2, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 180 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Mix two sources with faders.
Parts list
- Passives
- Audio
- Motors & Actuators
- PassivesResistor 10 kΩ × 2
- Passives
- Batteries
- Power
- Prototyping
How to build it
- Wire each fader
- Add the mixing resistors
- Feed a phone and a tone
- Listen to the mix
- Set both to the same level
Common questions
What parts do I need for the two-channel fader mixer?
Slide potentiometer 10 kΩ × 2, LM386 amplifier module, Speaker 8 Ω 0.5 W, Resistor 10 kΩ × 2, Electrolytic capacitor 10 µF × 2, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the two-channel fader mixer take to build?
About 180 minutes for a beginner maker.
