Idea
In short
How do you build a skipping rope counter?
A small motion sensor in one handle of a skipping rope counts each turn and shows the total and the jumps a minute on a screen. A button starts a new set. A fun way to meet motion sensing, and a gentle challenge to beat your own count. You need Arduino Nano, MPU6050 IMU, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Beginner
- Time
- About 80 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Count skips with a motion sensor.
Parts list
- Development Boards
- Sensors
- Displays
- Switches
- Prototyping
- Prototyping
How to build it
- Read the motion sensor in the handle
- Spot each swing of the rope
- Count a skip once per turn
- Show the total and the rate
- Start a new set with the button
Common questions
What parts do I need for the skipping rope counter?
Arduino Nano, MPU6050 IMU, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the skipping rope counter take to build?
About 80 minutes for a beginner maker.
