Projects / Ideas / Sensor response time dunk test

Sensor response time dunk test

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build a sensor response time dunk test?

Move a sealed probe and a waterproof thermistor from cool to warm water together and log how quickly each one follows. You see the time constant of each sensor, and why a slow sensor needs patience. Use water no hotter than about 50 degrees, and keep the electronics dry. You need Arduino Nano, DS18B20 waterproof probe, NTC 10 kΩ waterproof probe, Resistor 4.7 kΩ, Resistor 10 kΩ, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 90 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See which temperature sensor is faster.

How to build it

  1. Wire both sensors
  2. Log both once a second
  3. Start in cool water
  4. Move both into warm water together
  5. Find the time each takes to reach most of the change

Related projects

Common questions

What parts do I need for the sensor response time dunk test?

Arduino Nano, DS18B20 waterproof probe, NTC 10 kΩ waterproof probe, Resistor 4.7 kΩ, Resistor 10 kΩ, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the sensor response time dunk test take to build?

About 90 minutes for a intermediate maker.