Projects / Ideas / Noisy signal cleaner with a Schmitt inverter

Noisy signal cleaner with a Schmitt inverter

IntermediateDigital LogicIdeaReviewed
In short

How do you build a noisy signal cleaner with a Schmitt inverter?

A slow noisy input becomes a clean square edge through a Schmitt-trigger inverter, shown with LEDs and a scope or board counter. You need 74HC14 hex Schmitt-trigger inverter, Potentiometer 10 kΩ, Ceramic Capacitor 100 nF, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 150 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Clean a slow signal with hysteresis.

How to build it

  1. Wire one inverter as a buffer
  2. Feed a slow ramp from the pot
  3. Watch the LED flip without flicker
  4. Add an RC filter in front
  5. Measure the two thresholds

Related projects

Common questions

What parts do I need for the noisy signal cleaner with a Schmitt inverter?

74HC14 hex Schmitt-trigger inverter, Potentiometer 10 kΩ, Ceramic Capacitor 100 nF, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the noisy signal cleaner with a Schmitt inverter take to build?

About 150 minutes for a intermediate maker.