Projects / Ideas / Decade resistor box with a rotary switch

Decade resistor box with a rotary switch

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build a decade resistor box with a rotary switch?

Use a rotary switch and a string of resistors to make a stepped resistance box that you plug into a circuit in place of a resistor. It lets you find the right value by turning a knob instead of swapping parts. You need Rotary switch 1-pole 12-way, Resistor 100 Ω, Resistor 220 Ω, Resistor 470 Ω, Resistor 1 kΩ, Resistor 2.2 kΩ, Resistor 4.7 kΩ, Resistor 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 60 min
Parts
10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Find the right resistor value by turning a knob.

How to build it

  1. Sketch the switch and resistor chain
  2. Solder or breadboard the chain
  3. Label each knob position with its measured value
  4. Test it in an LED circuit
  5. Use it to pick a resistor for a timing circuit

Related projects

Common questions

What parts do I need for the decade resistor box with a rotary switch?

Rotary switch 1-pole 12-way, Resistor 100 Ω, Resistor 220 Ω, Resistor 470 Ω, Resistor 1 kΩ, Resistor 2.2 kΩ, Resistor 4.7 kΩ, Resistor 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the decade resistor box with a rotary switch take to build?

About 60 minutes for a intermediate maker.