Idea
In short
How do you build an RFID card tap demo?
Tap a card on an RFID reader to show the card's ID on a display and log a count, as a training demo with no personal data. You need Arduino Uno R3, RC522 RFID reader, SSD1306 OLED Display, Passive buzzer, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Read RFID card IDs over SPI.
Parts list
- Development Boards
- Wireless
- Displays
- Motors & Actuators
- Prototyping
- Prototyping
How to build it
- Wire the RC522 over SPI at 3.3 V
- Read card UIDs
- Show them on the OLED
- Beep on a known card
- Keep a tap counter in EEPROM
Common questions
What parts do I need for the RFID card tap demo?
Arduino Uno R3, RC522 RFID reader, SSD1306 OLED Display, Passive buzzer, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the RFID card tap demo take to build?
About 150 minutes for a intermediate maker.
