Idea
In short
How do you build a bedside exit chime?
A small radar sensor notices when someone gets out of bed and sounds a soft chime for a carer in another room. A learning aid, not a safety device. You need Arduino Nano, RCWL-0516 microwave radar motion sensor, Active buzzer 5 V, Resistor 1 kΩ, Tactile push button 6 mm and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Notice movement without touching.
Parts list
- Development Boards
- Sensors
- Motors & Actuators
- Passives
- Switches
- Prototyping
How to build it
- Wire the sensor
- Read the output
- Arm and disarm with a button
- Chime after a delay
- Tune the sensitivity
Common questions
What parts do I need for the bedside exit chime?
Arduino Nano, RCWL-0516 microwave radar motion sensor, Active buzzer 5 V, Resistor 1 kΩ, Tactile push button 6 mm and Breadboard 830 Tie Points.
How long does the bedside exit chime take to build?
About 180 minutes for a intermediate maker.
