Projects / Ideas / Buzz-the-time pocket clock

Buzz-the-time pocket clock

IntermediateAssistive TechIdeaReviewed
In short

How do you build a buzz-the-time pocket clock?

Press a button and a small vibration motor buzzes the time: long pulses for the hours and short pulses for the tens of minutes, so you can feel the time without looking. A neat idea for quiet places and for people who cannot see a screen. Keep the motor and battery safe. You need Arduino Nano, DS3231 RTC module, Vibration motor (coin type), BC547 NPN transistor, Signal Diode 1N4148, Resistor 1 kΩ, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 90 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Feel the time as pulses of vibration.

How to build it

  1. Read the time from the clock
  2. Count hours as long pulses
  3. Count tens of minutes as short pulses
  4. Drive the motor with a transistor
  5. Add a diode across the motor

Related projects

Common questions

What parts do I need for the buzz-the-time pocket clock?

Arduino Nano, DS3231 RTC module, Vibration motor (coin type), BC547 NPN transistor, Signal Diode 1N4148, Resistor 1 kΩ, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the buzz-the-time pocket clock take to build?

About 90 minutes for a intermediate maker.