Projects / Ideas / Pot loading effect lab

Pot loading effect lab

BeginnerLearningIdeaReviewed
In short

How do you build a pot loading effect lab?

Measure how a pot's output sags when a load is connected, with a one kilo-ohm and a ten kilo-ohm pot. You need Arduino Nano, Potentiometer 1 kΩ (linear), Potentiometer 10 kΩ, Resistor 10 kΩ, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Beginner
Time
About 120 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See divider loading.

How to build it

  1. Build the divider
  2. Read with no load
  3. Add a load
  4. Plot the sag for both pots
  5. Explain the difference

Related projects

Common questions

What parts do I need for the pot loading effect lab?

Arduino Nano, Potentiometer 1 kΩ (linear), Potentiometer 10 kΩ, Resistor 10 kΩ, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the pot loading effect lab take to build?

About 120 minutes for a beginner maker.