Idea
In short
How do you build a resettable fuse trip test?
A resettable fuse is tested with increasing current until it trips and then resets, measured safely at low voltage. You need Polyfuse (PTC resettable) 500 mA, Power resistor 10 Ω 5 W (cement), INA219 Current Monitor, Arduino Nano, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 150 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn how polyfuses work.
Parts list
- Passives
- Passives
- Sensors
- Development Boards
- Power
- Prototyping
How to build it
- Read the hold and trip currents
- Build a variable load from resistors
- Measure the current
- Find the trip point
- Time the reset
Common questions
What parts do I need for the resettable fuse trip test?
Polyfuse (PTC resettable) 500 mA, Power resistor 10 Ω 5 W (cement), INA219 Current Monitor, Arduino Nano, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
How long does the resettable fuse trip test take to build?
About 150 minutes for a beginner maker.
